this is the speaker setup we did for my OZ Rally, this was done to JBL Specs with two 4 ohm chambers and 1 1ohm chamber pushin over 2300 watts RMS its not the biggest yet it isnt the smallest finishing stapler 3/4 mdf fiberglass bondo felt jigsaw primer thinner paint some of the basic stuff! stock trunk (the 2 tens i had in there was just for make due lol) get the speakers get a plan (although it will change get a base plan and dimensions) start the box *******we fitted the box to the trunk several times******** OOps make sure when installing the rings there is not a ring already in the box ***** Fit your speakers after the rings to make sure everythign is clearing and the speakers fit****** felt it glass and sand and repeat as needed lol check speakers again while your resting during the glass drying go ahead and do some sound proofing the carpet was removed so we can put back in wire it up paint, install, lock down this added 500 lbs to my trunk minimum so we added 1 1/2" aluminum plate to the struts on the back to hold it off the Bridgestone 215/50 R17 potenza's also the when you lay your carpet back down we built it to be tight so we had to shave some of the facotry carpet off the humps to get it in tight. this project is not complete, we are doing some more eye pleasing stuff to it, but it is ready for compeition. hope yall enjoyed i ahve more photos but didnt want to take a tone of space up! stalrev http://www.myspace.com/stalrev Thanks to Dynamat JBL Tsunami PAC Optima Batteries
a sheet of red plexi glass has made it to the house so we will work on the amp covers tonight wahooooo!!!!
sorry show season been kicking our butts, then the Hot Import Nights canceling shows so we had to pick up others. here is the plexi glass me and my daughter did. we taped out the mits logo on the back and some tribal, then we used paint thinner to wipe away the mirror part. we then used 1/4 inch plywood and cut out the tribal. we hit that with some bondo and painted. now at night the mits shines from the leds under the amps.. we are thinking of moving the leds so it will be brighter. forgot the other photos that show the whole trunk, will put them up tomorrow
thanks we still have one piece i want to add to the plexi as you can tell in the photos it sorta sags a little at the box i want to brace that.. as well as move the leds i will try to get some night photos